APC Smart-UPS VT Spécifications télécharger pdf (Page 25)

21Smart-UPS VT ® 10-40 kVA 380/400/415 V, 208/220 V, 200/208 V Battery Installation

Install battery-securing and floor-anchoring brackets

1. Install the batteries by pushing them all the way into the enclosure.

2. If required, install the battery securing brackets to hold the batteries firmly in place. Note! Do not

install the bracket the same way they were positioned when the enclosure arrived. Rotate the

brackets 180º and reinstall.

Note: Battery securing brackets are delivered with the UPS or XR Battery Enclosure and

installed in front of the batteries. Extra battery securing brackets for additional batteries can be

purchased. Refer to kit SUVTOPT003: APC Smart-UPS VT Battery Lock Kit for one Battery

Module.

3. Install the L-shaped floor-anchoring bracket (reuse of transportation brackets) by adding four M6

screws and nuts (provided) to the enclosure (only if the optional U-shaped floor anchoring

brackets described in this manual have not been chosen).

4. Drill floor holes.

Note: If the floor has not been prepared for anchoring, see “Prepare for Floor-Anchoring

(optional)” on page 2.

5. Add a minimum of two M8 screws (not provided) to the anchoring bracket and tighten the

screws.

Battery securing bracket

L-shaped floor-anchoring

bracket (reuse of

transportation bracket)









1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

APC Smart-UPS VT Spécifications Page 25