APC MGE Galaxy 300 Guide de l'utilisateur télécharger pdf (Page 96)

Network Management Card User’s Guide87

Use a USB drive to transfer the files

Note: Before starting the transfer, make sure the USB drive is formatted in FAT32.

1. Download the update files and unzip them.

2. Create a folder named

apcfirm on the USB drive.

3. Place the extracted files in the

apcfirm directory.

4. Insert the USB drive into any USB port on the Network Management Card 2.

5. Reset the Network Management Card 2 and wait for the card to reboot fully.

6. Check that the upgrade was completed successfully using the procedures in “Verifying Upgrades

and Updates” on page 87.

Verifying Upgrades and Updates

Verify the success or failure of the transfer

To verify whether a firmware upgrade succeeded, use the xferStatus command in the command line

interface to view the last transfer result, or use an SNMP GET to the

mfiletransferStatusLastTransferResult OID.

Last Transfer Result codes

Verify the version numbers of installed firmware.

Use the Web interface to verify the versions of the upgraded firmware modules by selecting the

Administration tab, General on the top menu bar, and About on the left navigation menu, or use an

SNMP GET to the MIB II sysDescr OID. In the command line interface, use the

about command.

Code Description

Successful The file transfer was successful.

Result not available There are no recorded file transfers.

Failure unknown The last file transfer failed for an unknown reason.

Server inaccessible The TFTP or FTP server could not be found on the network.

Server access denied The TFTP or FTP server denied access.

File not found The TFTP or FTP server could not locate the requested file.

File type unknown The file was downloaded but the contents were not recognized.

File corrupt The file was downloaded but at least one Cyclical Redundancy Check (CRC) failed.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 104 105

Pas de commentaire

APC MGE Galaxy 300 Guide de l'utilisateur Page 96