APC Smart-UPS RC 96V Battery Pack Manuel d'utilisateur télécharger pdf (Page 4)

SRC96XLBP / SRC96XLBP2S User Manual 5

Installation

Units may vary in appearance from those depicted in this manual.

Always place UPS above XLBPs in rack-mount configuration.

Connect all battery strings. Failure to do so may cause equipment damage.

Refer to Physical Specifications in this manual and the Safety Guide before installing unit.

Unit is heavy. Batteries must be removed from unit prior to installation.

1. Remove screws securing battery compartment door. Remove door.

2. Grasp plastic flap attached to battery and pull to remove battery module.

Units in tower configuration, remove batteries at top of unit first.

Tower configuration

Install stabilizer brackets

1. Stabilizer brackets must be installed on tower units.

2. Each bracket must be secured with two flat head screws

(supplied).

NOTE: Screws are pre-installed on left side of unit.

These screws must be removed from unit and used to

secure stabilizer bracket. Screws for securing

stabilizer bracket to right side of unit are included in

hardware bag supplied with unit.

su0223a

su0224a

su212a

1 2 3 4 5 6 7 8 9 ... 14 15

Pas de commentaire

APC Smart-UPS RC 96V Battery Pack Manuel d'utilisateur Page 4