APC KVM1116P Manuel d'utilisateur télécharger pdf (Page 87)

75KVM Switch KVM2132P, KVM2116P, KVM1116P User Manual

Security

For increased security, administrators can set policies governing user log in failures. Check the Enable

checkbox (the default is enabled).

Note: If Login Failures is not enabled, users can attempt to log in an unlimited number of

times with no restrictions. For security purposes, enable the function and lockout policies.

Filter

IP and MAC Filtering

Control access to the KVM switch based on the IP and/or MAC addresses of the client computers

attempting to connect. A maximum of 100 IP filters and 100 MAC filters are allowed. If any filters have

been configured, they appear in the IP Filter and/or MAC Filter list boxes.

To enable, click to put a check mark in the IP Filter Enable and/or MAC Filter Enable checkbox.

• If the Include button is checked, all the addresses within the filter range are allowed access; all

other addresses are denied access.

• If the Exclude button is checked, all the addresses within the filter range are denied access; all

other addresses are allowed access.

Adding Filters

To add an IP filter:

1. Click Add to open the dialog box.

2. Specify an IPv4 or IPv6 address.

3. Enter the address you want to filter in the From: field.

– To filter a single IP address, click to put a check in the Single IP checkbox.

– To filter a continuous range of addresses, enter the end number of the range in the To: field.

Note: This description is for the AP GUI. The Browser GUI does not offer an IPv4 or

IPv6 choice. It only has From and To fields for IPv4 filtering and does not have a

checkbox to specify a single IP address. To filter a single IPv4 address, enter the same

address in both From and To fields.

4. After filling in the address, click OK.

5. Repeat the steps to filter additional IP addresses.

Entry Explanation

Allowed Sets the number of consecutive failed login attempts permitted from a remote computer. The

default is 5 times.

Timeout Sets the amount of time a remote computer must wait before attempting to login again after

exceeding the allowed failures. The default is 3 minutes.

Lock Client PC If enabled, after the allowed failures have been exceeded, the computer attempting to log in is

locked out. No logins from that computer will be accepted. The default is enabled.

Note: If the client computer's IP is changed, the computer will no longer be locked out.

Lock Account If enabled, after the allowed failures are exceeded, the user attempting to log in is

automatically locked out. No logins from the failed username and password will be accepted.

The default is enabled.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 133 134

Pas de commentaire

APC KVM1116P Manuel d'utilisateur Page 87