APC AP9622 Manuel d'installation télécharger pdf (Page 17)

Installation Manual

Command line interface

After you log on at the command line interface, as described in “Local access to

the command line interface” on page 11 or “Remote access to the command line

interface” on page 12, you can manually configure network settings.

1. Contact your network administrator to obtain the IP address, subnet

mask, and default gateway for the Network Management Card.

2. Use these three commands to configure network settings. (Text in italics

indicates a variable.)

a.tcpip -i yourIPaddress

b. tcpip -s yourSubnetMask

c. tcpip -g yourDefaultGateway

For each variable, type a numeric value that has the format

xxx.xxx.xxx.xxx.

For example, to set a system IP address of 156.205.14.141, type the

following command and press

ENTER:

tcpip -i 156.205.14.141

3. Type exit. The Network Management Card restarts to apply the

changes.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Pas de commentaire

APC AP9622 Manuel d'installation Page 17