APC PDM3563IEC-200 Manuel télécharger pdf

990-3079B-001

05/2008

*990-3079B-

Installation

InfraStruXure Power Distribution Module

Electrical Hazard. To prevent arcing when removing an

APC Power Distribution Module (PDM) from the Modular

Power Distribution Unit (PDU), set all PDMs to

OFF. Do not

remove the modules while they are still supporting the load.

Caution: PDMs must be replaced by trained personnel only.

Note: The PDM can be safely installed into a

powered rack.

Note: For PDMs with RCDs installed, the occurrence of an

earth fault will automatically open the adjacent circuit-

breaker.

Note: PDMs with RCDs are equipped with a test button.

Periodic testing of the RCD may be required. Check your

local codes.

See Operation Manual 990-3054 for more information.

How to unpack the Power Distribution Module

(PDM)



Remove the PDM from its carton.



Cut cable ties and unwind the power cable.

How to install the PDM

Note: Some Power Distribution Units have filler plates

installed. When a PDM is to be installed, the filler plate must

be removed from the busbar.



Press down on the clip.



Pull out the plate from the unit. (Do not throw away the filler plate.

Keep it for potential later use).



Verify that all the breakers are in the OFF position.



Press the red button to release the latch.



Pull open the latch.



Feed the cable(s) up through the top opening in the enclosure and

into the cable power troughs (if applicable) on top of enclosures.

position

PDM – Single and Three

phase

position

PDM with RCD (Residual Current

Devices) - Three phase

PDM with RCD – Single phase

position

Test buttonTest button













Vertical Rack Distribution Panel

Busbar

cover



Horizontal Rack Distribution Panel

1 2

Installation 1
Contact Information 2

Résumé du contenu

Page 1 - Installation

990-3079B-00105/2008*990-3079B-InstallationInfraStruXure Power Distribution Module Electrical Hazard. To prevent arcing when removing an APC Power Dis

Page 2 - Contact Information

2Slide the PDM all the way into the slots. Close the latch to secure the module in the busbar.Use plastic ties to secure loose cable(s) to the enclo

Commentaires sur ces manuels

Pas de commentaire

APC PDM3563IEC-200 Manuel

Naviguer en ligne ou télécharger Manuel pour Unités de distribution d'électricité (PDU) APC PDM3563IEC-200. APC PDM1316IEC-3P power distribution unit PDU Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Unités de distribution d'électricité (PDU) APC PDM3563IEC-200