APC AR8132 Fiche technique télécharger pdf

990-1264 1 of 4 02/2003

NetShelter

AR8132—Combination Lock

To remove the NetShelter lock:

1. Remove the screws from the lock.

2. Remove the handle and screw plate from the NetShelter enclosure.

To replace the cam:

• If your rack has a latch bracket that is 1.35 inches (34.3 mm) deep, use the cam that is pre-

installed on the combination lock.

• If your rack has a latch bracket that is 2.17 inches (55.2 mm) deep, replace the pre-installed cam

with the smaller cam (provided).

a. Remove the screw holding the pre-installed cam in place. Slide the cam off the lock.

b. Replace the old cam with the smaller cam and secure it in place, using the screw removed in step a.

1 2 3 4

Résumé du contenu

Page 1 - NetShelter

990-1264 1 of 4 02/2003NetShelter®®AR8132—Combination LockTo remove the NetShelter lock:1. Remove the screws from the lock.2. Remove the handle and sc

Page 2

NetShelter Combination Lock 2 of 4To install the combination lock (smaller cam shown):1. Slide the handle through the two openings in the enclosure wh

Page 3 - To change the combination:

NetShelter Combination Lock 3 of 4To set the lock:1. Turn the wing knob(0) until the arrow(.) points down (locked position /).2. Jumble the combinatio

Page 4 - 990-1264 02/2003

APC Worldwide Customer SupportCustomer support for this or any other APC product is available at no charge in any of the following ways:• Visit the AP