APC NBWL0456 Guide d'installation télécharger pdf (Page 12)

NetBotz Wireless Sensor Pod 180 Installation Guide

External installation

The Wireless Sensor Pod ships with a mounting plate to be used when installing

a pod in a non-rack location or in a non-Netshelter VX, SX, or SV rack.

1. Separate the two pieces of the plastic push rivets.

Note: To avoid equipment damage, use only the hardware

provided when installing the brackets.

2. Place the included mounting plate on the back of the pod and align the

holes with the mounting holes on the pod.

3. Insert the outer sleeves into the mounting holes on the rear of the plate.

4. Insert the plastic rivets into the anchor sleeves.

5. Use the appropriate hardware to mount the Wireless Sensor Pod in the

desired location.

Connecting a Door Switch or Temperature Sensor

Only connect sensors that are supported by the Wireless Sensor Pod. Each

Wireless Sensor Pod can monitor and control up to three door switch sensors or

temperature sensors. Connect sensors to the universal sensor ports on the

Wireless Sensor Pod.

Caution: Only connect approved devices to ports on the Wireless

Sensor Pod as directed in this manual. Plugging in other devices

may result in equipment damage not covered under warranty.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Pas de commentaire

APC NBWL0456 Guide d'installation Page 12