APC SBPSU10K30FC1M1-WP Manuel d'installation télécharger pdf (Page 14)

Smart-UPS® VT and MGE™ Galaxy™ 3500 10-30 kVA 208 V MBP Installation 10

Internal cable connections

For the convenience of the installer, ALL internal MBP cable connections were made prior to shipment.

Check to make certain the following internal cable connections were completed:

• Power Terminal Block [L1, L2, L3, N, top-to-bottom] to Input Bus [L1, L2, L3, N, top-to-

bottom]

• Output Bus [L1, L2, L3, top-to-bottom] to Input Fuse Block [L1, L2, L3, top-to-bottom]

• Output Bus [N] to Neutral Bar [N]

• Output Fuse Block [L1, L2, L3, top-to-bottom] to Panel Board [L1, L2, L3, left-to-right]

• Neutral Bar [N] to Neutral Bar [N] (refer to “Internal components” on page 4)

• Control Terminal Block to optional customer contacts [1, 2, 3, 4, 5, 6] and UPS connections for

Q3 [7, 8]. Note: The control wires from the UPS MUST

be connected to the Normally Closed

Auxiliary Contacts on Q3 [7, 8]. DO NOT

use terminals 5 and 6 for these connections! Refer to

“Schematic” on page 5 and to the appropriate wiring diagram in the UPS Installation Manual.

Power Terminal Block

to Input Bus [L1, L2, L3, N]

Output Bus

to Input Fuse

Output Bus

to Neutral Bar [N]

Output Fuse Block

to Panel Board

Block [L1, L2, L3]

[L1, L2, L3]

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

APC SBPSU10K30FC1M1-WP Manuel d'installation Page 14