APC KVM1116P Manuel d'utilisateur télécharger pdf (Page 82)

KVM Switch KVM2132P, KVM2116P, KVM1116P User Manual 70

IPv6 Settings

IP Address:

IPv6 is the new (128-bit) format for specifying IP addresses. (See “IPv6” on page 106 for further

information.) The KVM switch can either have its IPv6 address assigned dynamically (DHCP), or it can

be given a fixed IP address.

• For dynamic IP address assignment, select the Obtain IP address automatically radio button.

(The default setting.)

• To specify a fixed IP address, select the Set IP address manually radio button and fill in the

fields with values appropriate for your network.

DNS Server

• For automatic DNS Server address assignment, select the Obtain DNS Server address

automatically radio button.

• To specify the DNS Server address manually, select the Set DNS server address manually radio

button, and fill in the addresses for the Preferred and Alternate DNS servers with values

appropriate for your network.

Note: Specifying the Alternate DNS Server address is optional.

Network Transfer Rate

This setting allows you to tailor the size of the data transfer stream to match network traffic conditions

by setting the rate at which the KVM switch transfers data between itself and the client computers. The

range is from 4-99999 Kilobytes per second (KBps).

Finishing

Be sure to enable Reset on exit on the Device Management > System Operation page (see “Reset on

exit” on page 94), before logging out to allow network changes to take effect without powering the

switch off and on.

ANMS

Use ANMS (Advanced Network Management Settings) to set up login authentication and authorization

management from external sources. It is organized as a notebook with two tabs, each with a series of

related panels.

Event Destination.

SMTP Settings

To have the KVM switch email reports from the SMTP server to you:

1. Enable the Enable report from the following SMTP server, and enter the IPv4 address, IPv6

address, or domain name of the SMTP server.

2. If your server requires a secure SSL connection, put a check in the My server requires secure

connection (SSL) checkbox.

3. If your server requires authentication, put a check in the My server requires authentication

checkbox, and enter the account information in the Account Name and Password fields.

4. Enter the email address where the report will be sent in the From field. Put only one email

address in the From field. It cannot exceed 64 Bytes.

5. Enter the email address (addresses) where you want the SMTP reports sent in the To field.

Note: If the report will be sent to more than one email address, separate the addresses

with a semicolon. The total cannot exceed 256 Bytes.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 133 134

Commentaires sur ces manuels

Pas de commentaire

APC KVM1116P Manuel d'utilisateur Page 82

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs KVM APC KVM1116P