APC Automatic Disconnect Switch Guide de l'utilisateur télécharger pdf (Page 157)

USER’S GUIDE

AUTOMATIC TRANSFER SWITCH

154

Configure or reconfigure the TCP/IP settings locally

To configure a single Network Management Card through a serial

connection:

1. Contact your network administrator to obtain valid TCP/IP settings.

2. Connect the serial configuration cable that came with the Network

Management Card or with the device that contains an embedded

Network Management Card.

a. Connect one end to an available communications port on your

computer. Make sure no other application is using the port.

b. Connect the other end to the serial port of the card or device.

3. From the Start menu, launch the Wizard application.

– If the Network Management Card is not configured, wait for the

Wizard to detect it.

– If you are assigning basic TCP/IP settings serially to a Network

Management Card, click Next> to move to the next screen.

4. Select Locally (through the serial port), and click Next >.

5. Enter the TCP/IP settings (System IP, Subnet Mask, and Default

Gateway) for the Network Management Card. Then click Next >.

6. On the Transmit Current Settings Remotely screen, if you check-

mark Start a Web browser when finished, the default Web browser

connects to the device that contains the Network Management Card

after you transmit the card’s settings.

7. Click Finish to transmit the TCP/IP settings. If the IP address you

entered is in use on the network, the Wizard prompts you to enter an IP

address that is not in use. Enter a correct IP address, and click Finish.

8. If you selected Start a Web browser when finished in step 6, you can

now configure other parameters through the Web interface of the card

or device.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 191 192

Pas de commentaire

APC Automatic Disconnect Switch Guide de l'utilisateur Page 157