APC PD80G6FK1-M Manuel de service télécharger pdf (Page 67)

Start-Up Procedure

990-1467C InfraStruXure System – Service Manual – Installation and Start-Up 59

1. Close (turn ON) the Q2 circuit breaker on the PDU.

The interface will display the following fault message:

a. Select Start up on Batt, and press the

ENTER key.

The interface will display the following screen:

The UPS interface displays the following fault screen:

b. Press any key.

The UPS interface displays the following fault screen:

c. Press the

ESC key.

The LOAD ON LED illuminates and the interface displays the following screen:

Low/No AC input

Start up on Batt?

Start Now

UPS has been

commanded to turn

load power on...

Bypass not available

Press any key...

Input Freq/Volt out of range

End of Fault List

keys to view list again

Press Esc to exit or other

UPS load is on

Press any key...

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 95 96

Pas de commentaire

APC PD80G6FK1-M Manuel de service Page 67