APC Network Management Card AP9617 Guide de l'utilisateur télécharger pdf (Page 145)

®®

USER’S GUIDE

network management card

138

When Boot mode is set to DHCP & BOOTP, two options are available:

• After IP Assignment in the control console (or Remain in DHCP &

BOOTP mode after accepting TCP/IP settings in the Web interface):

By default, this option switches Boot mode to the selection based on

the server that provided the TCP/IP settings (DHCP Only or BOOTP

Only).

• DHCP Cookie Is in the control console (or Require vendor specific

cookie to accept DHCP Address in the Web interface): By default,

this option requires that the DHCP responses include the APC cookie

in order to be valid.

When Boot mode is set to DHCP Only. two options are available:

• DHCP Cookie Is in the control console (or Require vendor specific

cookie to accept DHCP Address in the Web interface): By default,

this option requires that the DHCP responses include the APC cookie

in order to be valid.

• Retry Then Stop in the control console (Maximum # of Retries in the

Web interface), This option sets the number of times the Management

Card will repeat the DHCP request if it does not receive a valid

response. The default setting (0 in the Web interface, None in the

control console), requires that the Management Card continuously

send out DHCP requests until a valid DHCP response is received.

For more information about the APC cookie, see DHCP

response options.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 189 190

Pas de commentaire

APC Network Management Card AP9617 Guide de l'utilisateur Page 145