APC PD80G6FK1-M Manuel de service télécharger pdf (Page 36)

Installation ProceduresConnect AC Power and Control Wiring

28 InfraStruXure System – Service Manual – Installation and Start-Up 990-1467C

Connect control wiring.

4. Connect the EPO control wires from the PDU and Battery Enclosure to the EPO board on the

UPS. The control wires are harnessed and coiled in the floor of the PDU and Battery Enclosure,

respectively. The PDU harness connects to a 4-pin molex connector labeled J6 and the Battery

Enclosure harness connects to a 4-pin molex connector labeled J8.

14 13 12 11 10 9 8 7 6 5 4 3 2 1

4321

8765

1 Internal Power +24V Supply

2/3 Relay Coil 1

4 Ground

J6—Connect from PDU0W4510C

J8—Connect 0W1696

from Battery Enclosure

1 Internal Power

+24V Supply

2/3 NC

4 Ground

psx0328a

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 95 96

Pas de commentaire

APC PD80G6FK1-M Manuel de service Page 36