APC PD80G6FK1-M Manuel de service télécharger pdf (Page 83)

990-1467C InfraStruXure System – Service Manual – Installation and Start-Up 75

How to Apply Power to the System

This procedure instructs on how to apply power to a system that has already been installed. For initial

start-up instructions, see InfraStruXure 80kW Installation and Start-Up.

1. Set the upstream utility, and, if applicable, the

bypass input and cross tie utility circuit breaker

to ON.

1. Set the Main Input (A) breaker (or switch) on

the PDU to ON.

2. Close (turn ON) the Q1 circuit breaker on the

PDU to apply power to the UPS.

3. If applicable, set the Q10 Bypass

Input (B) breaker (or switch) on the PDU to

ON.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 95 96

Pas de commentaire

APC PD80G6FK1-M Manuel de service Page 83