APC NetBotz 200 Guide de l'utilisateur télécharger pdf (Page 97)

USER’S GUIDE

NetBotz Rack Monitor 200

APC Device IP Configuration Wizard

Capabilities, Requirements, and Installation

How to use the Wizard to configure TCP/IP settings

The APC Device IP Configuration Wizard configures the IP address, subnet mask, and

default gateway of one or more Network Management Cards or APC network-enabled

devices (devices containing an embedded Network Management Card). You can use

the Wizard in either of the following ways:

• Remotely over your TCP/IP network to discover and configure unconfigured Network

Management Cards or devices on the same network segment as the computer

running the Wizard.

• Through a direct connection from a serial port of your computer to a Network

Management Card or device to configure or reconfigure it.

System requirements

The Wizard runs on computers with Microsoft Windows 2000, Windows Server

2003,

or Windows XP operating systems.

Installation

To install the Wizard from the NetBotz Rack Monitor 200 Utility CD:

1. If autorun is enabled, the user interface of the CD starts when you insert the

CD. Otherwise, open the file contents.htm on the CD.

2. Click Device IP Configuration Wizard and follow the instructions.

To install the Wizard from a downloaded executable file:

1. Go to www.apc/tools/download.

2. Download the Device IP Configuration Wizard.

3. Run the executable file in the folder to which you downloaded it.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 124 125

Pas de commentaire

APC NetBotz 200 Guide de l'utilisateur Page 97