APC NetBotz 200 Guide de l'utilisateur télécharger pdf (Page 98)

USER’S GUIDE

NetBotz Rack Monitor 200

Use the Wizard

Launch the Wizard

The installation creates a shortcut link in the Start menu to launch the Wizard.

Configure the basic TCP/IP settings remotely

Prepare to configure the settings. Before you run the Wizard:

1. Contact your network administrator to obtain valid TCP/IP settings.

2. If you are configuring multiple unconfigured Network Management Cards or

network-enabled devices, obtain the MAC address of each one to identify it

when the Wizard discovers it. (The Wizard displays the MAC address on the

screen on which you then enter the TCP/IP settings.)

• For a Network Management Card that you install, the MAC address is on a label

on the bottom of the card.

• For a network-enabled device (with an embedded Network Management Card),

the MAC address is on a label on the device.

• You can also obtain the MAC address from the Quality Assurance slip that came

with the Network Management Card or device.

Most software firewalls must be temporarily disabled for the Wizard to discover

unconfigured Network Management Cards or devices.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 124 125

Pas de commentaire

APC NetBotz 200 Guide de l'utilisateur Page 98