APC NetBotz 200 Guide de l'utilisateur télécharger pdf (Page 99)

USER’S GUIDE

NetBotz Rack Monitor 200

Run the Wizard to perform the configuration. To discover and configure

unconfigured Network Management Cards or network-enabled devices over the

network:

1. From the Start menu, launch the Wizard. The Wizard detects the first Network

Management Card or network-enabled device that is not configured.

2. Select Remotely (over the network), and click Next >.

3. Enter the system IP, subnet mask, and default gateway for the Network

Management Card or device identified by the MAC address. Click Next >.

On the Transmit Current Settings Remotely screen, if you select Start a Web

browser when finished, the default Web browser connects to the Network

Management Card or device after the Wizard transmits the settings.

4. Click Finish to transmit the settings. If the IP address you entered is in use on

the network, the Wizard prompts you to enter an IP address that is not in use.

Enter a correct IP address, and click Finish.

5. If the Wizard finds another unconfigured Network Management Card or device,

it displays the screen to enter TCP/IP settings. Repeat this procedure

beginning at step 3, or to skip the Network Management Card or device whose

MAC address is currently displayed, click Cancel.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 124 125

Pas de commentaire

APC NetBotz 200 Guide de l'utilisateur Page 99